Flouncy Flower Headband How-to | Tutorials

Make a floucy flower headband out of an old shirt.

Step 1Tools

What you will need:

* 1/8 yard of Flouncy Fabric (such as chiffon)
* Sharp Scissors
* Straight Pins
* Sewing Needle
* Thread
* Medium to large sized button
* Headband
* Square of felt
* Glue Gun
Step 2Print Pattern

Download the image Flouncy Flower pattern and size it appropriately . Print pattern out pattern.

Step 3 Cut petals

Cut 12 flower petals using the flower petal pattern from the fabric. HINT: Since the fabric is thin you can cut out several at a time by layering the fabric.

Thread the needle using at least a foot of thread. Place needle close at hand for next step.

 
Step 4 Fold

Take a flower petal and fold it in half lengthwise (fig. 4A). Take the folded petal and fold it in half a second time (fig. 4B).

Step 5 Sew

Pick up the needle and thread and put a holding stitch at the bottom point of the folded petal (fig. 5).
Step 6Repeat steps

Repeat step four with a second flower petal.

Step 7 Second Petal

Stitch the second petal base to the first petal. HINT: I often run a second stitch through the petals to keep them in place, making it easier to attach the others (fig.7).

Step 8 Repeat with remaining petal

Repeat steps six and seven. When stitching the remaining petals to the base attach them in a circular pattern around the original petal (fig. 8).

Step 9 Knot thread

After the last petal is attached knot off the thread to secure the petals in place and cut off the excess thread tale. The flower should look like fig. 9.

Step 10 Sew button

Flatten out the flower and sew a button to the center of the flower (fig. 10).

Step 11 Backer

Cut out the a piece of felt using the backer pattern (fig. 11).

Step 12 Attach to headband

Determine where you would like to place the flower on the headband. You can lightly mark this area with a wax pencil or sharpie if needed. Hot glue the flower to the backer MAKING SURE TO SANDWICH THE HEADBAND between the two.

Step 13 Finished